The T1N Sprinter Van M-Series aluminum system can hold up 750 lbs. 3 bars evenly distributed.
The Crossbars is 2″ X 1″ reinforced extruded aluminum with built-in channels.
The Crossbar is protected by a non-slip rubber bar guard on top that is easily pressed into the channels.
The aluminum mounting upright is approx. 1/8″ thick at the base.
The mounting uprights are 8in wide at the base and 16.5″ total height. The Base is welded complete onto the upright post for complete seal. There are 4X 3/4″ eyehooks per mounting upright. There is absolutely No drilling required, secures with drip rail clamps.
The drip rail clamps are 11-gauge galvanized steel/powder coated 2″ X 8″ dipped in rubber top and bottom. Rubber cap on the upright post prevents wind noise and water leakage. The system Includes 5″ ladder stopper to prevent ladder from sliding forward, Ladder stoppers are galvanized and rubber dipped.
The system also includes 5.5″ ladder guide for easy bungee and tie-down. Ladder guide are galvanized and rubber dipped.
Easy turn knob allows quick adjustments and removal of ladder stopper and ladder guide. Hook & loop straps secure ladders within seconds up to 75 lbs. (Bar guards, Ladder stopper, ladder guide, hook & loop straps only available in our 2,3,4 bar systems).
System is powder coated for additional protection against corrosion. The H1 system is made to be vehicle specific for 100% fitment.
The Vantech aluminum M-Series Top mount roof rack system with 72″ cross bars that can be installed your T1N Sprinter Van (drilling required)
These are not Gutter Mounted. The are mounted on the Roof, You will need to drill thru the roof.
With Choices of Black or White, Also Available in Steel, but for $20 less a rail we believe Aluminum is the way to go.
The mounting bases are 3 mm thick and have an extra wide 6″ X 1.5″ mounting base, polyfoam gasket and 1″ X 5″ interior plate secures the rack system onto your T1N 2001-2006 Sprinter Van.
This system weighs in at 14 lbs. with stainless steel hardware with aMax load capacity of this system is 250 lbs. per bar.
The Vantech steel M-Series top mount rack system (drilling required).
The extra wide 6″ X 1.5″ mounting base, polyfoam gasket and 1″ X 5″ interior plate secures the rack system onto the vehicle.