How to Install an A/C Refrigerant Discharge Hose (Discharge Line) on a T1N 2006 Sprinter Van Tools & Materials Needed:

  • New A/C refrigerant discharge hose (discharge line)
  • Wrenches (sizes may vary)
  • Socket set
  • Torque wrench
  • Refrigerant recovery machine (optional but recommended)
  • Gloves and safety glasses
  • O-rings (if required by new hose)
  • A/C refrigerant (to recharge the system)

Other A/C hose Lines Links

A/C Refrigerant Liquid Hose  

A/C Suction Line Hose Assembly


Step-by-Step Instructions:

1. Safety First: Before starting, ensure the vehicle is parked on a flat surface, and the engine is turned off. It is recommended to wear gloves and safety glasses for protection. 2. Recover Refrigerant: If there is any refrigerant left in the system, you must first recover it using a refrigerant recovery machine. This step is crucial, as releasing refrigerant into the environment is illegal and harmful. If you don’t have access to a recovery machine, have a professional do this step for you. 3. Locate the Discharge Hose: The discharge hose connects the A/C compressor to the condenser. In the T1N 2006 Sprinter, the A/C compressor is usually located at the front of the engine bay, near the bottom, while the condenser is mounted near the front radiator. 4. Remove the Old Discharge Hose:

  • Disconnect from the Compressor: Use the appropriate size wrench to loosen and disconnect the discharge hose from the A/C compressor. Keep track of any bolts, nuts, or washers that may come off during this process.
  • Disconnect from the Condenser: Trace the hose to the condenser and disconnect it in a similar manner using a wrench or socket.
  • Remove any clamps or brackets securing the discharge hose along its path.

5. Inspect and Replace O-Rings:

  • Inspect the O-rings at the connection points for wear or damage. If the new discharge hose doesn’t come with O-rings, it’s a good idea to replace the old ones to ensure a proper seal.
  • Lightly lubricate the new O-rings with refrigerant oil to help them seat properly and prevent leaks.

6. Install the New Discharge Hose:

  • Connect to the Compressor: Attach the new hose to the A/C compressor and tighten the bolts to the manufacturer’s specified torque using a torque wrench.
  • Connect to the Condenser: Attach the other end of the hose to the condenser and secure it with the appropriate bolts, again tightening to the correct torque.
  • Reinstall any clamps or brackets that hold the hose in place.

7. Double Check Connections: Make sure all connections are secure and properly tightened. This will help prevent refrigerant leaks and ensure the system works efficiently. 8. Recharge the A/C System:

  • With the new hose installed, you will need to recharge the system with the correct type and amount of refrigerant for the 2006 Sprinter van.
  • If you are unfamiliar with this process or don’t have the necessary equipment, it is highly recommended to have a professional perform this step.

9. Test the A/C System:

  • Start the engine and turn on the A/C to verify that the system is working correctly.
  • Check for any unusual noises, leaks, or weak airflow from the vents. If everything is functioning properly, you’re good to go!

10. Final Inspection: After running the system for a few minutes, inspect the connections and surrounding areas for any signs of refrigerant leaks. If everything looks secure, the installation is complete.


By following these steps, you should have successfully installed the new A/C refrigerant discharge hose on your 2006 Sprinter van. If you encounter any issues or are unsure about any part of the process, it’s best to consult a professional mechanic.  Â